Reflect-A-Light™ KLF3 - 2' X 2' Three Piece Full Coverage Reflector for 2' X 2' Fixtures

Total Luminaire Efficiency: 68.9%
Luminaire: Formed steel housing, formed aluminum specular reflector, .125 clear prismatic lens.
Lamps: Two F17T8/TL841 rated 1350 Lumens each.
Ballast: Electronic 2FO17

• Increases Fixture Efficiency to over 68%
• Maintenance cost reduced because U-Tubes are replaced
• Reduces glare effect of standard fixtures
• Computer designed for maximum light output
• 25 Year Warranty on Reflector
• Kit includes Reflector and two Socket Brackets

Applications:

Full coverage reflectors for 2' X 2' fixtures. Maximizes fixture efficiency, providing even light distribution with both acrylic and parabolic lensed fixtures. The center piece of the reflector is the new ballast cover and easily snaps in and out of the fixture for maintenance.

Construction:

The standard Reflectors are constructed of highly polished, high purity anodized aluminum. Material form, fit and thickness meets or exceeds all UL 1570 requirements. Computer Assisted Design provides maximum light output, even light distribution, rigid strength and ballast access without the use of tools.

Material:

The standard reflector material has a minimum of 93% Image Clarity (D/I) and 86% Reflectivity (TR). The durable surface is highly resistent to scratching and non-abrasive commercial cleaning solutions, making the reflector easy to clean. Warranted for 25 years.

Installation:

Installation of the KLF Series reflector kit is simple and easy, requiring only basic hand tools. Remove the existing lamps, install new ballast and install new socket brackets. Reflector is then easily attached to the socket brackets with the selected mounting options described below.

Mounting (the following fastener type comes standard):

Wingnut KLF3 BRA1 Bracket

Ordering Guide (standard kit):

The KLF3/SA/2 is a three piece full reflector, designed for two optimally spaced 2' bi-pin T8 or T12 straight tube lamps (replaces U-Tubes). It includes one set of BRA1 brackets. Reflector mounts to the brackets with a simple wingnut fastener. Allows consistent installation and easy access to ballast without the use of tools.